MetalworkingFun Forum › Machining › General Metalworking Discussion v
Cutting Stainless Sheet

Thread Modes
Cutting Stainless Sheet
SteveG Offline
Sophmore
***
Posts: 130
Threads: 17
Joined: Dec 2016
Location: Melbourne, Australia
#2
01-15-2018, 09:59 PM
Guillotine (ideally), shear or bandsaw would be my suggestions.

Steve
Reply
Thanks given by:


Messages In This Thread
Cutting Stainless Sheet - by f350ca - 01-15-2018, 09:50 PM
RE: Cutting Stainless Sheet - by SteveG - 01-15-2018, 09:59 PM
RE: Cutting Stainless Sheet - by f350ca - 01-15-2018, 10:39 PM
RE: Cutting Stainless Sheet - by SteveG - 01-16-2018, 01:54 AM
RE: Cutting Stainless Sheet - by Highpower - 01-16-2018, 09:49 AM
RE: Cutting Stainless Sheet - by Vinny - 01-16-2018, 11:00 AM
RE: Cutting Stainless Sheet - by Dr Stan - 01-16-2018, 11:33 AM
RE: Cutting Stainless Sheet - by f350ca - 01-16-2018, 01:13 PM



Users browsing this thread: 1 Guest(s)