The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] Cutting A Taper On Lathe

Thread Modes
Help Cutting A Taper On Lathe
Cross Slide Offline
Sophmore
***
Posts: 109
Threads: 24
Joined: Aug 2016
Location: Regina Saskatchewan Canada
#1
01-26-2018, 08:59 PM
I need some help. 
I’m attempting to cut a taper on my lathe by swiveling the compound. 
The math has me confused at what angle to set my compound at. 
D=0.693
d=0.663
Angle is 0.30
1/2 of A=0.15
L=1.000
Can someone help me figure this out?
I have the Engineers Black Book. BUT.
I’m lost trying to figure out Tangents

Who knew my high school math teacher was going to be right!!!

Thanks
Cross Slide
Trevor
Reply
Thanks given by:


Messages In This Thread
Cutting A Taper On Lathe - by Cross Slide - 01-26-2018, 08:59 PM
RE: Cutting A Taper On Lathe - by EdK - 01-26-2018, 09:35 PM
RE: Cutting A Taper On Lathe - by Hawkeye - 01-26-2018, 11:31 PM
RE: Cutting A Taper On Lathe - by Vinny - 01-27-2018, 04:24 PM
RE: Cutting A Taper On Lathe - by Hopefuldave - 01-28-2018, 07:54 AM



Users browsing this thread: 1 Guest(s)