MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] Cutting A Taper On Lathe

Thread Modes
Help Cutting A Taper On Lathe
Hawkeye Offline
Junior
****
Posts: 532
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada
#3
01-26-2018, 11:31 PM
Just guessing, but it looks like a total included angle of 1.719 degrees, or a setting of 0.8596 degrees off axis.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Cutting A Taper On Lathe - by Cross Slide - 01-26-2018, 08:59 PM
RE: Cutting A Taper On Lathe - by EdK - 01-26-2018, 09:35 PM
RE: Cutting A Taper On Lathe - by Hawkeye - 01-26-2018, 11:31 PM
RE: Cutting A Taper On Lathe - by Vinny - 01-27-2018, 04:24 PM
RE: Cutting A Taper On Lathe - by Hopefuldave - 01-28-2018, 07:54 AM



Users browsing this thread: 1 Guest(s)