|
Help Tight offset bend
|
02-09-2018, 07:19 AM
I'm a little late to the party, but since it's a production part, a Z shaped bending/forming die would be worth the effort. It could be angled so that both bends started at the same time and would require the mating parts to have a 5/32" radius on them to keep from flattening the rod. Small die sets are available from McMaster Carr.
Tom ![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Tight offset bend - by Mike s. - 02-05-2018, 08:42 PM
RE: Tight offset bend - by SteveG - 02-05-2018, 10:36 PM
RE: Tight offset bend - by Hawkeye - 02-05-2018, 11:35 PM
RE: Tight offset bend - by Mike s. - 02-06-2018, 06:57 PM
RE: Tight offset bend - by Vinny - 02-06-2018, 09:04 PM
RE: Tight offset bend - by randyc - 02-08-2018, 10:03 PM
RE: Tight offset bend - by Dr Stan - 02-06-2018, 07:32 PM
RE: Tight offset bend - by Hawkeye - 02-06-2018, 11:31 PM
RE: Tight offset bend - by TomG - 02-09-2018, 07:19 AM
|
