New Lathe Tool On Order
#2
(03-20-2018, 07:19 PM)the penguin Wrote: For some unknown reason, I decided I wanted/needed a new lathe tool, I use a MTJNR tool, that uses the TNMG 321/322/323 inserts. There are times I wish I had a smaller version of the same tool.

Welp, while perusing the BangGood site today, There was a smaller version of the MTJNR tool, using the TNMG 1604 size insert, with a 16 mm shank.

Is It perfect, probably not, but it should be better.

The tool and 20 inserts was about $40.

I'll post pictures when it gets here.

Jack,

Do you have a link to the tool?

Ed
Reply
Thanks given by:


Messages In This Thread
New Lathe Tool On Order - by the penguin - 03-20-2018, 07:19 PM
RE: New Lathe Tool On Order - by EdK - 03-21-2018, 03:54 PM
RE: New Lathe Tool On Order - by the penguin - 03-21-2018, 06:44 PM
RE: New Lathe Tool On Order - by EdK - 03-21-2018, 08:15 PM
RE: New Lathe Tool On Order - by the penguin - 03-21-2018, 08:36 PM
RE: New Lathe Tool On Order - by EdK - 03-21-2018, 09:00 PM



Users browsing this thread: 1 Guest(s)