Drilling 95% Tungsten Darts
#4
You might want to consider "slightly" shortening the tungsten barrels in the lathe, which should allow you to more easily remove minute amounts of material and accurately establish equal weight for the set. Also, using wire flight shafts which come in different lengths can reduce weight.
Mike
Reply
Thanks given by:


Messages In This Thread
Drilling 95% Tungsten Darts - by Wongster - 12-15-2018, 02:24 AM
RE: Drilling 95% Tungsten Darts - by TomG - 12-15-2018, 11:07 AM
RE: Drilling 95% Tungsten Darts - by Wongster - 12-16-2018, 08:46 AM
RE: Drilling 95% Tungsten Darts - by TomG - 12-16-2018, 09:44 AM
RE: Drilling 95% Tungsten Darts - by awemawson - 12-15-2018, 01:17 PM
RE: Drilling 95% Tungsten Darts - by Mike E. - 12-16-2018, 06:07 AM
RE: Drilling 95% Tungsten Darts - by Wongster - 12-16-2018, 08:49 AM
RE: Drilling 95% Tungsten Darts - by Mike E. - 12-16-2018, 09:24 AM
RE: Drilling 95% Tungsten Darts - by Wongster - 12-23-2018, 08:36 PM
RE: Drilling 95% Tungsten Darts - by Umahunter - 12-27-2018, 05:01 AM
RE: Drilling 95% Tungsten Darts - by Roadracer_Al - 12-31-2018, 01:40 PM



Users browsing this thread: 1 Guest(s)