MetalworkingFun Forum › Machining › Gunsmithing v
Barrel rail for revolvers

Thread Modes
Barrel rail for revolvers
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,795
Threads: 183
Joined: Jun 2012
Location: Farmington Hills, Michigan
#6
02-02-2019, 12:28 PM
It looks like you've cut quite a ways into the barrel. How do you know that hasn't compromised the strength of the barrel to the point where it is unsafe? Better talk to an engineer and have them calculate the strength of what's left based on the pressures involved.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Barrel rail for revolvers - by Velocity Villan - 02-01-2019, 03:36 PM
RE: Barrel rail for revolvers - by Mike E. - 02-01-2019, 06:09 PM
RE: Barrel rail for revolvers - by Dr Stan - 02-01-2019, 11:03 PM
RE: Barrel rail for revolvers - by Dr Stan - 02-01-2019, 11:04 PM
RE: Barrel rail for revolvers - by Mike E. - 02-02-2019, 05:51 AM
RE: Barrel rail for revolvers - by TomG - 02-02-2019, 12:28 PM
RE: Barrel rail for revolvers - by EdK - 02-02-2019, 01:41 PM
RE: Barrel rail for revolvers - by Dr Stan - 02-05-2019, 10:32 AM
RE: Barrel rail for revolvers - by Roadracer_Al - 02-05-2019, 06:30 PM



Users browsing this thread: 1 Guest(s)