drill project
#6
(05-13-2012, 02:37 PM)doubleboost Wrote: Bob
What sort of "acid" do you use
John

I know other Bob but i use Muratic Acid in water in my shop as i have for the last 25 years. Sometimes i use it full strength and it takes just a few minutes then neutralize in baking soda, dry and then oil so it won't re rust or prime and paint...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
drill project - by krv3000 - 05-13-2012, 01:35 PM
RE: drill project - by krv3000 - 05-13-2012, 01:52 PM
RE: drill project - by doubleboost - 05-13-2012, 02:03 PM
RE: drill project - by krv3000 - 05-13-2012, 02:31 PM
RE: drill project - by doubleboost - 05-13-2012, 02:37 PM
RE: drill project - by aametalmaster - 05-13-2012, 02:41 PM
RE: drill project - by krv3000 - 05-13-2012, 04:39 PM
RE: drill project - by krv3000 - 05-13-2012, 04:05 PM
RE: drill project - by doubleboost - 05-13-2012, 04:11 PM
RE: drill project - by krv3000 - 05-13-2012, 05:11 PM
RE: drill project - by Rickabilly - 06-11-2012, 08:36 AM
RE: drill project - by doubleboost - 05-13-2012, 05:17 PM
RE: drill project - by krv3000 - 05-13-2012, 05:32 PM
RE: drill project - by krv3000 - 05-13-2012, 05:39 PM
RE: drill project - by Highpower - 05-13-2012, 09:15 PM
RE: drill project - by DaveH - 05-14-2012, 05:49 AM
RE: drill project - by Mayhem - 05-14-2012, 06:07 AM
RE: drill project - by stevec - 05-14-2012, 07:43 AM
RE: drill project - by EdK - 05-14-2012, 08:19 AM
RE: drill project - by ETC57 - 05-14-2012, 01:58 PM
RE: drill project - by Mayhem - 05-14-2012, 08:27 AM
RE: drill project - by krv3000 - 05-15-2012, 01:58 AM
RE: drill project - by krv3000 - 06-05-2012, 06:06 PM
RE: drill project - by stevec - 06-11-2012, 03:24 PM



Users browsing this thread: 1 Guest(s)