09-21-2019, 08:08 PM
Got the new motor installed, both VFDs, checked out the table feed and it works well. I'm going to make a panel for it to put the speed and direction controls in a more handy location, have two Cutler-Hammer switches en route, 10K pots and knobs I have.
The scales for the DRO should be here this week. Then I'll be making a new motor plate, the plate on it now is far from perfect, it's even far from good, it's even far from ok, it just works... for now.
Here's how it looks currently...
The scales for the DRO should be here this week. Then I'll be making a new motor plate, the plate on it now is far from perfect, it's even far from good, it's even far from ok, it just works... for now.
Here's how it looks currently...
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique
the nobucks boutique etsy shop | the nobucks boutique