Xometry.com
#10
Needed to move it once, only had one pipe to put under it, hence the wheels. I had to do the initial wiring. If the belt for the table ever goes, I'll need to move it again. Hopefully not again for a long time!
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:


Messages In This Thread
Xometry.com - by Paulc - 10-14-2019, 03:02 PM
RE: Xometry.com - by Vinny - 10-14-2019, 09:45 PM
RE: Xometry.com - by Highpower - 11-08-2019, 05:14 PM
RE: Xometry.com - by Vinny - 11-08-2019, 10:33 PM
RE: Xometry.com - by Highpower - 11-08-2019, 11:44 PM
RE: Xometry.com - by Paulc - 11-09-2019, 02:45 PM
RE: Xometry.com - by Highpower - 11-09-2019, 09:14 PM
RE: Xometry.com - by Vinny - 11-10-2019, 12:06 AM
RE: Xometry.com - by Highpower - 11-10-2019, 12:53 AM
RE: Xometry.com - by Vinny - 11-10-2019, 02:40 PM
RE: Xometry.com - by Vinny - 11-26-2019, 03:30 PM
RE: Xometry.com - by Highpower - 11-30-2019, 03:04 PM
RE: Xometry.com - by Paulc - 11-27-2019, 03:24 PM
RE: Xometry.com - by Vinny - 11-29-2019, 09:45 PM
RE: Xometry.com - by Paulc - 11-30-2019, 03:18 PM
RE: Xometry.com - by Paulc - 12-01-2019, 03:23 PM
RE: Xometry.com - by Highpower - 12-27-2019, 11:53 AM
RE: Xometry.com - by Paulc - 12-29-2019, 03:40 PM
RE: Xometry.com - by Highpower - 12-29-2019, 05:11 PM
RE: Xometry.com - by EdK - 12-29-2019, 05:45 PM
RE: Xometry.com - by Paulc - 12-30-2019, 03:32 PM



Users browsing this thread: 1 Guest(s)