|
Mill a circle
|
|
10-19-2019, 08:00 PM
(10-19-2019, 03:25 PM)Dr Stan Wrote: Just added a HT furnace to my "need" list.  By the way Stan, what goes around comes around. Watching Joe's videos cost me dearly in the last couple of weeks. I now own not one, but two vintage magnetic dial indicator holders (US General and a Craftsman) because of that guy. I also got one of his rotary table alignment pins in the mail today. 
Willie
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Mill a circle - by Paulc - 10-17-2019, 03:11 PM
RE: Mill a circle - by Highpower - 10-17-2019, 08:06 PM
RE: Mill a circle - by Paulc - 10-17-2019, 08:18 PM
RE: Mill a circle - by Dr Stan - 10-17-2019, 08:57 PM
RE: Mill a circle - by rleete - 10-18-2019, 08:36 AM
RE: Mill a circle - by Paulc - 10-18-2019, 03:11 PM
RE: Mill a circle - by Dr Stan - 10-18-2019, 07:31 PM
RE: Mill a circle - by Highpower - 10-19-2019, 10:48 AM
RE: Mill a circle - by Dr Stan - 10-19-2019, 03:25 PM
RE: Mill a circle - by Highpower - 10-19-2019, 08:00 PM
RE: Mill a circle - by Paulc - 10-19-2019, 03:39 PM
RE: Mill a circle - by Dr Stan - 10-19-2019, 04:36 PM
|
