Mill or drill??
#7
In this case it was just two spacers for a shaft
Reply
Thanks given by:


Messages In This Thread
Mill or drill?? - by Paulc - 11-02-2019, 03:15 PM
RE: Mill or drill?? - by EdK - 11-02-2019, 06:30 PM
RE: Mill or drill?? - by Highpower - 11-02-2019, 07:58 PM
RE: Mill or drill?? - by Paulc - 11-03-2019, 11:26 AM
RE: Mill or drill?? - by Highpower - 11-03-2019, 12:19 PM
RE: Mill or drill?? - by EdK - 11-03-2019, 01:06 PM
RE: Mill or drill?? - by Paulc - 11-03-2019, 02:30 PM



Users browsing this thread: 1 Guest(s)