MetalworkingFun Forum › Machining › General Shop Stuff v
Thermostat help

Thread Modes
Thermostat help
Vinny Online
Another Whipping Boy
*******
Posts: 2,596
Threads: 99
Joined: Dec 2014
Location: Michigan
#9
12-07-2019, 09:11 PM
I made a curing oven for plastics (I think there's a pic of it in the plastics forum) using a 150 watt bulb and a PID controller. Works great! I probably got the PID controller on ebay, doubt I spent more than $20 for it and it holds the temp where I need it to within about 2 degrees - but that is also settable.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Website
Reply
Thanks given by:


Messages In This Thread
Thermostat help - by Dr Stan - 12-06-2019, 06:04 PM
RE: Thermostat help - by Pete O - 12-06-2019, 06:09 PM
RE: Thermostat help - by Dr Stan - 12-06-2019, 10:36 PM
RE: Thermostat help - by TomG - 12-06-2019, 07:25 PM
RE: Thermostat help - by f350ca - 12-06-2019, 09:18 PM
RE: Thermostat help - by Dr Stan - 12-06-2019, 10:38 PM
RE: Thermostat help - by Highpower - 12-07-2019, 12:18 AM
RE: Thermostat help - by Highpower - 12-07-2019, 12:04 AM
RE: Thermostat help - by Vinny - 12-07-2019, 09:11 PM



Users browsing this thread: 1 Guest(s)