MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
Boring Bar

Thread Modes
Boring Bar
Highpower Offline
JAFO
******
Posts: 4,369
Threads: 178
Joined: Feb 2012
Location: Missouri, USA
#4
12-21-2019, 12:41 PM
What type of tool post are you using? Square 4-position or QCTP?
What type of boring bars? Like these?
[Image: HTB1vTqLPVXXXXaJXpXXq6xXFXXXf.jpg]


I find the brazed carbide tools work much better after being ground to a sharp edge and a decent clearance angle. Center height is the correct way to go.
Willie
Reply
Thanks given by:


Messages In This Thread
Boring Bar - by Cross Slide - 12-21-2019, 10:19 AM
RE: Boring Bar - by EdK - 12-21-2019, 11:49 AM
RE: Boring Bar - by Cross Slide - 12-21-2019, 12:22 PM
RE: Boring Bar - by Highpower - 12-21-2019, 12:41 PM
RE: Boring Bar - by Cross Slide - 12-22-2019, 06:37 PM
RE: Boring Bar - by Highpower - 12-22-2019, 10:45 PM
RE: Boring Bar - by Cross Slide - 12-23-2019, 09:46 PM
RE: Boring Bar - by Dr Stan - 12-21-2019, 01:09 PM
RE: Boring Bar - by Cross Slide - 12-22-2019, 06:42 PM
RE: Boring Bar - by rleete - 12-21-2019, 02:26 PM
RE: Boring Bar - by TomG - 12-23-2019, 09:46 AM
RE: Boring Bar - by Cross Slide - 12-23-2019, 09:50 PM
RE: Boring Bar - by TomG - 12-23-2019, 10:53 PM
RE: Boring Bar - by rleete - 12-23-2019, 07:56 PM
RE: Boring Bar - by Highpower - 12-23-2019, 08:49 PM
RE: Boring Bar - by Dr Stan - 12-24-2019, 12:11 AM
RE: Boring Bar - by Highpower - 12-24-2019, 11:30 AM
RE: Boring Bar - by Dr Stan - 12-24-2019, 12:20 PM
RE: Boring Bar - by Highpower - 12-24-2019, 12:53 PM
RE: Boring Bar - by EdK - 12-24-2019, 12:59 PM



Users browsing this thread: 2 Guest(s)