|
Drill Chuck Tap Handle
|
12-25-2019, 11:28 PM
(12-25-2019, 10:54 PM)Dr Stan Wrote: I'd check with local gunsmiths about blueing or see if there is a plating shop in the area that can black phosphate the parts. BTW, looks like you did a nice job. Thanks Stan.
Lathe - Craftex CX701, Mill - Craftex B30 Mill/Drill, DRO - blu-DRO
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Drill Chuck Tap Handle - by Cross Slide - 12-25-2019, 05:19 PM
RE: Drill Chuck Tap Handle - by Dr Stan - 12-25-2019, 10:54 PM
RE: Drill Chuck Tap Handle - by Cross Slide - 12-25-2019, 11:28 PM
RE: Drill Chuck Tap Handle - by TomG - 12-26-2019, 10:23 AM
RE: Drill Chuck Tap Handle - by Cross Slide - 12-26-2019, 10:43 AM
RE: Drill Chuck Tap Handle - by rleete - 12-27-2019, 09:48 AM
RE: Drill Chuck Tap Handle - by KarlH - 01-27-2020, 08:31 AM
RE: Drill Chuck Tap Handle - by Highpower - 01-27-2020, 01:38 PM
RE: Drill Chuck Tap Handle - by Vinny - 01-27-2020, 11:18 PM
|
