Drill Chuck Tap Handle
#5
(12-26-2019, 10:23 AM)TomG Wrote: Looks good! Thumbsup
I like the double duty feature of the screw in handle.
You may also want to check out my video on power tapping for a simple way to tap on the mill.

Brownell's carries a cold blue that works very well. It's called Oxpho-Blue.

Tom

Thanks Tom. 
I have watched your video on power tapping. Unfortunately my Mill doesn’t have reverse, as of yet anyway! So power tapping would be a bit of a pain right now. 
I would like to get reverse set up on my Mill at some point.

I will check out the cold blue from Brownell. 

Trevor
Lathe - Craftex CX701, Mill - Craftex B30 Mill/Drill, DRO - blu-DRO
Reply
Thanks given by:


Messages In This Thread
Drill Chuck Tap Handle - by Cross Slide - 12-25-2019, 05:19 PM
RE: Drill Chuck Tap Handle - by Dr Stan - 12-25-2019, 10:54 PM
RE: Drill Chuck Tap Handle - by Cross Slide - 12-25-2019, 11:28 PM
RE: Drill Chuck Tap Handle - by TomG - 12-26-2019, 10:23 AM
RE: Drill Chuck Tap Handle - by Cross Slide - 12-26-2019, 10:43 AM
RE: Drill Chuck Tap Handle - by rleete - 12-27-2019, 09:48 AM
RE: Drill Chuck Tap Handle - by KarlH - 01-27-2020, 08:31 AM
RE: Drill Chuck Tap Handle - by Highpower - 01-27-2020, 01:38 PM
RE: Drill Chuck Tap Handle - by Vinny - 01-27-2020, 11:18 PM



Users browsing this thread: 1 Guest(s)