Atlas TH42
#11
Thanks for all your help chaps, glad to say its fixed!

I removed the gearbox assembly from the lathe and had it all in pieces and still couldnt figure out what was wrong until i really tried to twist the gear on the shaft and there was some movement, it felt fixed in my hand but under enough load i managed to twist it, it had been glued in previously by somebody and so it was spinning, there were no holes in the bronze bush for attaching pins, so i had to drill some and make some pins, which i can do now because i have a lathe! haha.


https://www.dropbox.com/h?preview=VID_20...113537.mp4


Attached Files Thumbnail(s)
   
Reply
Thanks given by:


Messages In This Thread
Atlas TH42 - by impman76 - 12-28-2019, 12:31 PM
RE: Atlas TH42 - by Highpower - 12-28-2019, 02:38 PM
RE: Atlas TH42 - by EdK - 12-28-2019, 02:46 PM
RE: Atlas TH42 - by impman76 - 12-28-2019, 05:08 PM
RE: Atlas TH42 - by impman76 - 12-30-2019, 05:01 AM
RE: Atlas TH42 - by Highpower - 12-30-2019, 12:08 PM
RE: Atlas TH42 - by impman76 - 12-30-2019, 02:47 PM
RE: Atlas TH42 - by Highpower - 12-30-2019, 03:58 PM
RE: Atlas TH42 - by Dr Stan - 12-30-2019, 07:24 PM
RE: Atlas TH42 - by impman76 - 12-31-2019, 11:26 AM
RE: Atlas TH42 - by Highpower - 12-31-2019, 01:05 PM
RE: Atlas TH42 - by impman76 - 12-31-2019, 01:43 PM
RE: Atlas TH42 - by Highpower - 12-31-2019, 02:41 PM
RE: Atlas TH42 - by impman76 - 12-31-2019, 05:22 PM
RE: Atlas TH42 - by Dr Stan - 01-05-2020, 03:49 PM
RE: Atlas TH42 - by Highpower - 01-05-2020, 08:09 PM



Users browsing this thread: 1 Guest(s)