|
Looking for Ball Turning Plans
|
|
01-06-2020, 09:55 AM
I built the one from plans provided on HMEM, I believe. It is the one that has a round base, and mounts to the cross slide.
After further searching, it is the Steve Bedair design from http://bedair.org/Ball/ball.html Works very well, I just don't use it much.
Full of ideas, but slow to produce parts
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Looking for Ball Turning Plans - by Cross Slide - 01-05-2020, 09:29 PM
RE: Looking for Ball Turning Plans - by Dr Stan - 01-05-2020, 11:46 PM
RE: Looking for Ball Turning Plans - by rleete - 01-06-2020, 09:55 AM
RE: Looking for Ball Turning Plans - by Cross Slide - 01-06-2020, 07:05 PM
RE: Looking for Ball Turning Plans - by EdK - 01-06-2020, 10:54 AM
RE: Looking for Ball Turning Plans - by Cross Slide - 01-06-2020, 07:06 PM
RE: Looking for Ball Turning Plans - by EdK - 01-07-2020, 12:05 AM
RE: Looking for Ball Turning Plans - by arvidj - 01-07-2020, 02:21 PM
RE: Looking for Ball Turning Plans - by EdK - 01-07-2020, 03:13 PM
RE: Looking for Ball Turning Plans - by EdK - 01-07-2020, 03:20 PM
RE: Looking for Ball Turning Plans - by Cross Slide - 01-07-2020, 07:32 PM
RE: Looking for Ball Turning Plans - by EdK - 01-07-2020, 07:35 PM
|
