Boring tapered hole
#4
Do you have a taper attachment?

I made some SB spindle adapters with a MT3 hole and ended up boring the hole. I used a very sharp bit on the end of a 3.5" hang boring bar, fine feed and medium speed. I had to run a couple of spring passes because of the overhang and small OD boring bar. It took a while, but the results were very good - a MT3 center stuck like glue.
Reply
Thanks given by:


Messages In This Thread
Boring tapered hole - by Paulc - 01-18-2020, 03:34 PM
RE: Boring tapered hole - by Highpower - 01-18-2020, 08:24 PM
RE: Boring tapered hole - by TomG - 01-19-2020, 09:38 AM
RE: Boring tapered hole - by SLK001 - 01-19-2020, 10:06 AM
RE: Boring tapered hole - by Highpower - 01-19-2020, 01:02 PM
RE: Boring tapered hole - by Paulc - 01-19-2020, 04:01 PM
RE: Boring tapered hole - by Highpower - 01-19-2020, 04:37 PM
RE: Boring tapered hole - by Paulc - 01-19-2020, 08:39 PM
RE: Boring tapered hole - by TomG - 01-19-2020, 09:24 PM
RE: Boring tapered hole - by Paulc - 01-20-2020, 02:05 PM
RE: Boring tapered hole - by TomG - 01-20-2020, 03:27 PM
RE: Boring tapered hole - by Paulc - 01-21-2020, 02:42 PM
RE: Boring tapered hole - by Paulc - 01-21-2020, 09:51 PM
RE: Boring tapered hole - by Vinny - 01-22-2020, 09:38 AM
RE: Boring tapered hole - by Paulc - 01-22-2020, 03:00 PM
RE: Boring tapered hole - by Dr Stan - 02-23-2020, 05:46 PM
RE: Boring tapered hole - by Paulc - 02-23-2020, 03:57 PM
RE: Boring tapered hole - by ALPHAWOLF45 - 02-23-2020, 06:22 PM
RE: Boring tapered hole - by ALPHAWOLF45 - 02-23-2020, 06:45 PM
RE: Boring tapered hole - by ALPHAWOLF45 - 02-23-2020, 07:31 PM
RE: Boring tapered hole - by Paulc - 02-23-2020, 08:01 PM
RE: Boring tapered hole - by ALPHAWOLF45 - 02-24-2020, 01:58 PM
RE: Boring tapered hole - by Paulc - 02-24-2020, 03:13 PM
RE: Boring tapered hole - by ALPHAWOLF45 - 02-25-2020, 02:14 PM
RE: Boring tapered hole - by Paulc - 02-25-2020, 03:44 PM
RE: Boring tapered hole - by ALPHAWOLF45 - 02-27-2020, 02:24 PM
RE: Boring tapered hole - by Paulc - 02-27-2020, 03:19 PM
RE: Boring tapered hole - by Paulc - 02-27-2020, 03:28 PM



Users browsing this thread: 1 Guest(s)