MetalworkingFun Forum › Machining › General Shop Stuff v
[HELP] Machining Question

Thread Modes
Help Machining Question
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,795
Threads: 183
Joined: Jun 2012
Location: Farmington Hills, Michigan
#10
05-09-2020, 11:21 PM
Don,

Your setup looks rigid enough. What are you using to hold the end mill, because if that isn't concentric, the hole the end mill produces will be oversize. Have you tried running an indicator on the end mill to see?

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Machining Question - by Don - 05-04-2020, 03:41 PM
RE: Machining Question - by f350ca - 05-04-2020, 05:19 PM
RE: Machining Question - by TomG - 05-04-2020, 06:31 PM
RE: Machining Question - by EdK - 05-04-2020, 09:39 PM
RE: Machining Question - by Highpower - 05-05-2020, 12:48 PM
RE: Machining Question - by Vinny - 05-05-2020, 08:37 PM
RE: Machining Question - by Don - 05-09-2020, 11:56 AM
RE: Machining Question - by Highpower - 05-10-2020, 11:28 AM
RE: Machining Question - by Don - 05-09-2020, 01:15 PM
RE: Machining Question - by EdK - 05-09-2020, 03:47 PM
RE: Machining Question - by TomG - 05-09-2020, 11:21 PM
RE: Machining Question - by Don - 05-10-2020, 01:34 PM
RE: Machining Question - by Don - 05-10-2020, 11:48 PM
RE: Machining Question - by Highpower - 05-11-2020, 07:59 PM
RE: Machining Question - by awemawson - 05-11-2020, 02:00 AM
RE: Machining Question - by Don - 05-11-2020, 10:48 AM
RE: Machining Question - by Don - 05-12-2020, 12:35 PM
RE: Machining Question - by Highpower - 05-12-2020, 02:11 PM
RE: Machining Question - by Don - 05-12-2020, 04:35 PM
RE: Machining Question - by Highpower - 05-12-2020, 08:16 PM



Users browsing this thread: 1 Guest(s)