New bike project.
#5
Please make a post about building a manometer.  When I rebuild the engine (a 383 high performance) I intend on getting a Tri-power manifold and running it on 3 two barrel carbs with the middle carb supplying the majority of gas during normal driving.  When I get on it is when I want the extra fuel from the front and back carbs.  Edelbrock made the intake manifolds and every now & then one is listed on EBay.  Once I get serious about the rebuild I'll need to start searching for a manifold.
Reply
Thanks given by:


Messages In This Thread
New bike project. - by toglhot - 05-14-2020, 07:28 AM
RE: New bike project. - by toglhot - 07-07-2020, 08:33 PM
RE: New bike project. - by toglhot - 07-07-2020, 08:41 PM
RE: New bike project. - by TomG - 07-08-2020, 12:03 PM
RE: New bike project. - by Dr Stan - 07-08-2020, 12:26 PM
RE: New bike project. - by toglhot - 07-08-2020, 06:57 PM
RE: New bike project. - by toglhot - 08-28-2020, 03:22 AM
RE: New bike project. - by toglhot - 01-02-2023, 04:53 PM
RE: New bike project. - by toglhot - 01-02-2023, 05:07 PM
RE: New bike project. - by toglhot - 01-02-2023, 05:20 PM
RE: New bike project. - by EdK - 01-02-2023, 05:52 PM
RE: New bike project. - by toglhot - 01-02-2023, 06:39 PM
RE: New bike project. - by Highpower - 01-03-2023, 09:11 AM
Lubrication system mods. - by toglhot - 01-03-2023, 07:39 PM
Exhaust pipes. - by toglhot - 01-06-2023, 04:01 AM
Muffler build. - by toglhot - 01-06-2023, 04:09 AM
Handlebar riser build. - by toglhot - 01-07-2023, 01:04 AM
RE: Handlebar riser build. - by Lockwood1956 - 01-13-2023, 05:37 AM
RE: New bike project. - by TomG - 01-13-2023, 09:08 AM
Clutch slave cylinder build. - by toglhot - 01-17-2023, 02:08 AM



Users browsing this thread: 1 Guest(s)