New bike project.
#7
Finished off the front hub:  I drilled the disk with some lightning holes, installed new sealed bearings, polished the hub and because the left side cover that covers the disk mount holes was rusted, I fabbed a new aluminium one and polished that as well.  Bought some stainless fasteners, polished them up and assembled the hub.  I want to go with an electronic speedo, if I can find one, so the speedo drive on the left will probably go and I'll turn up a stainless spacer in it's place.  For a bit of extra bling, I also polished the edge of the disk.  Hub should look nice laced up to a polished ally rim with polished stainless spokes.


Attached Files Thumbnail(s)
                   
Reply
Thanks given by:


Messages In This Thread
New bike project. - by toglhot - 05-14-2020, 07:28 AM
RE: New bike project. - by toglhot - 07-07-2020, 08:33 PM
RE: New bike project. - by toglhot - 07-07-2020, 08:41 PM
RE: New bike project. - by TomG - 07-08-2020, 12:03 PM
RE: New bike project. - by Dr Stan - 07-08-2020, 12:26 PM
RE: New bike project. - by toglhot - 07-08-2020, 06:57 PM
RE: New bike project. - by toglhot - 08-28-2020, 03:22 AM



Users browsing this thread: 1 Guest(s)