MetalworkingFun Forum › Machining › 3D Printing v
[HELP] Printing Problem

Thread Modes
Help Printing Problem
EdK Offline
Whipping Boy
*******
Posts: 8,742
Threads: 313
Joined: Feb 2012
Location: Arizona/Minnesota
#8
07-29-2020, 02:21 PM
I figured out how to use the preview feature and I'm not seeing any artifacts that would cause the issue. I created a new g-code file and it's 1.3M larger than the original file that I created so I'm printing it again to see if it does the same thing.

Ed
Reply
Thanks given by:


Messages In This Thread
Printing Problem - by EdK - 07-28-2020, 12:55 PM
RE: Printing Problem - by arvidj - 07-28-2020, 04:39 PM
RE: Printing Problem - by EdK - 07-28-2020, 06:30 PM
RE: Printing Problem - by arvidj - 07-28-2020, 07:01 PM
RE: Printing Problem - by EdK - 07-29-2020, 09:29 AM
RE: Printing Problem - by arvidj - 07-29-2020, 10:05 AM
RE: Printing Problem - by EdK - 07-29-2020, 12:23 PM
RE: Printing Problem - by EdK - 07-29-2020, 02:21 PM
RE: Printing Problem - by EdK - 07-29-2020, 04:03 PM
RE: Printing Problem - by EdK - 07-29-2020, 07:58 PM
RE: Printing Problem - by Vinny - 07-29-2020, 09:38 PM
RE: Printing Problem - by arvidj - 07-29-2020, 09:57 PM
RE: Printing Problem - by Vinny - 07-30-2020, 11:27 AM
RE: Printing Problem - by EdK - 07-30-2020, 01:08 AM
RE: Printing Problem - by EdK - 07-30-2020, 01:17 PM
RE: Printing Problem - by Vinny - 07-31-2020, 11:05 PM
RE: Printing Problem - by EdK - 08-12-2020, 04:06 PM
RE: Printing Problem - by arvidj - 08-14-2020, 09:39 AM
RE: Printing Problem - by EdK - 08-14-2020, 09:55 AM



Users browsing this thread: 1 Guest(s)