MetalworkingFun Forum › Machining › General Metalworking Discussion v
Machinist files

Thread Modes
Machinist files
Clifford B. Offline
Sophmore
***
Posts: 51
Threads: 6
Joined: Jun 2016
Location: Whats left of America
The following 1 user Likes Clifford B.'s post:
Mike E. (08-19-2020)
#6
08-19-2020, 01:19 AM
(08-18-2020, 09:51 PM)Dr Stan Wrote: It's not difficult nor time consuming to build a reverse electrolysis set up.  I made one using rebar, a large plastic tote and a battery charger as the power supply.

Do you have a schematic handy to post ..??       Smiley-eatdrink004
Reply
Thanks given by:


Messages In This Thread
Machinist files - by rleete - 08-18-2020, 09:47 AM
RE: Machinist files - by f350ca - 08-18-2020, 11:52 AM
RE: Machinist files - by Dr Stan - 08-18-2020, 12:02 PM
RE: Machinist files - by rleete - 08-18-2020, 12:57 PM
RE: Machinist files - by Dr Stan - 08-18-2020, 09:51 PM
RE: Machinist files - by Clifford B. - 08-19-2020, 01:19 AM
RE: Machinist files - by Dr Stan - 08-19-2020, 12:38 PM
RE: Machinist files - by TomG - 08-19-2020, 08:21 AM
RE: Machinist files - by Clifford B. - 08-19-2020, 02:06 PM
RE: Machinist files - by rleete - 09-09-2020, 06:53 PM



Users browsing this thread: