Reamer
#3
(01-10-2021, 12:32 AM)Dr Stan Wrote: Turn down the shank of the reamer or bore the hole.

That’s good to know. I didn’t realize I could turn the shank down. For some reason I thought it would be hardened.

As for boring the cylinder out, my boring bars suck. I haven’t had any luck getting a good finish with them yet. Definitely wouldn’t be a good enough finish for a cylinder and piston. 

But I will try turning the shank down.

Trevor
Lathe - Craftex CX701, Mill - Craftex B30 Mill/Drill, DRO - blu-DRO
Reply
Thanks given by:


Messages In This Thread
Reamer - by Cross Slide - 01-10-2021, 12:00 AM
RE: Reamer - by Dr Stan - 01-10-2021, 12:32 AM
RE: Reamer - by Cross Slide - 01-10-2021, 09:39 AM
RE: Reamer - by TomG - 01-10-2021, 10:40 AM
RE: Reamer - by Cross Slide - 01-10-2021, 12:06 PM
RE: Reamer - by TomG - 01-10-2021, 12:45 PM
RE: Reamer - by Dr Stan - 01-10-2021, 11:15 AM
RE: Reamer - by Cross Slide - 01-10-2021, 12:09 PM
RE: Reamer - by Dr Stan - 01-10-2021, 02:11 PM
RE: Reamer - by f350ca - 01-10-2021, 09:27 PM
RE: Reamer - by rleete - 01-11-2021, 09:43 AM
RE: Reamer - by Highpower - 01-11-2021, 10:46 AM



Users browsing this thread: 1 Guest(s)