02-10-2021, 02:22 PM
Typically I used 3 or 4 inch wide by 6 to 8 inch long drops of channel iron. Welded a piece on each end and called it good. The taper on the inside of the channel made it easy to remove the ingots.
|
Make your own ingot molds.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Make your own ingot molds. - by Patrick-C - 02-10-2021, 01:52 AM
RE: Make your own ingot molds. - by Dr Stan - 02-10-2021, 02:22 PM
RE: Make your own ingot molds. - by Patrick-C - 02-16-2021, 12:36 AM
RE: Make your own ingot molds. - by FlingZ - 11-08-2021, 02:51 AM
RE: Make your own ingot molds. - by Dr Stan - 11-08-2021, 09:29 AM
RE: Make your own ingot molds. - by FlingZ - 07-10-2022, 07:27 AM
|
Users browsing this thread: 1 Guest(s)