Converting a 12x36 lathe to 3-phase power.

Hello There, Guest! Register

Thread Modes

Converting a 12x36 lathe to 3-phase power.

doubleboost Offline

Offline

Super Moderator

Posts: 1,459
Threads: 159
Joined: Feb 2012
Location: Northern England

#2

05-21-2012, 04:18 PM

Hi
I have a VFD on my Boxford
They make screw cutting a pleasure
One thing to watch is motor temperature when running very slow
John

http://www.youtube.com/user/doubleboost

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Converting a 12x36 lathe to 3-phase power. - by Highpower - 05-20-2012, 09:46 PM

RE: Converting a 12x36 lathe to 3-phase power. - by doubleboost - 05-21-2012, 04:18 PM

RE: Converting a 12x36 lathe to 3-phase power. - by Highpower - 05-21-2012, 09:52 PM

RE: Converting a 12x36 lathe to 3-phase power. - by Hopefuldave - 05-22-2012, 01:37 PM

RE: Converting a 12x36 lathe to 3-phase power. - by starlight_tools - 05-25-2012, 05:28 PM

RE: Converting a 12x36 lathe to 3-phase power. - by DaveH - 05-22-2012, 01:55 PM

RE: Converting a 12x36 lathe to 3-phase power. - by Highpower - 05-22-2012, 04:01 PM

RE: Converting a 12x36 lathe to 3-phase power. - by EdK - 05-22-2012, 04:44 PM

RE: Converting a 12x36 lathe to 3-phase power. - by Highpower - 05-22-2012, 10:18 PM

RE: Converting a 12x36 lathe to 3-phase power. - by stevec - 05-23-2012, 07:38 AM

RE: Converting a 12x36 lathe to 3-phase power. - by EdK - 05-23-2012, 08:03 AM

RE: Converting a 12x36 lathe to 3-phase power. - by DanH - 05-23-2012, 12:31 PM

RE: Converting a 12x36 lathe to 3-phase power. - by Highpower - 05-23-2012, 09:07 PM

Users browsing this thread: 1 Guest(s)