MetalworkingFun Forum › Machinery › Milling Machines v
Tooling question for RF-45 clone

Thread Modes
Tooling question for RF-45 clone
Highpower Offline
JAFO
******
Posts: 4,369
Threads: 178
Joined: Feb 2012
Location: Missouri, USA
#7
05-22-2012, 11:20 AM
(05-22-2012, 11:00 AM)DanH Wrote: The weight goes up from 80 lbs to 129 lbs which is not so good for my back

DanH

That's why I have a 6 inch table. Big Grin

Dan, I believe the free shipping from Enco is limited to less than 125 lbs.
Better check with them on that.... Chin
Willie
Reply
Thanks given by:


Messages In This Thread
Tooling question for RF-45 clone - by DanH - 05-21-2012, 04:20 PM
RE: Tooling question for RF-45 clone - by EdK - 05-21-2012, 06:18 PM
RE: Tooling question for RF-45 clone - by krv3000 - 05-21-2012, 06:19 PM
RE: Tooling question for RF-45 clone - by ETC57 - 05-21-2012, 07:11 PM
RE: Tooling question for RF-45 clone - by DanH - 05-22-2012, 11:00 AM
RE: Tooling question for RF-45 clone - by Highpower - 05-22-2012, 11:20 AM
RE: Tooling question for RF-45 clone - by EdK - 05-22-2012, 11:34 AM
RE: Tooling question for RF-45 clone - by DanH - 05-22-2012, 12:14 PM
RE: Tooling question for RF-45 clone - by EdK - 05-22-2012, 04:38 PM
RE: Tooling question for RF-45 clone - by DanH - 05-22-2012, 04:49 PM
RE: Tooling question for RF-45 clone - by EdK - 05-22-2012, 05:09 PM
RE: Tooling question for RF-45 clone - by DanH - 05-22-2012, 06:12 PM
RE: Tooling question for RF-45 clone - by EdK - 05-22-2012, 07:20 PM
RE: Tooling question for RF-45 clone - by EdK - 05-23-2012, 08:05 AM
RE: Tooling question for RF-45 clone - by stevec - 05-23-2012, 08:03 AM
RE: Tooling question for RF-45 clone - by EdK - 05-24-2012, 07:07 AM
RE: Tooling question for RF-45 clone - by stevec - 05-24-2012, 06:31 AM
RE: Tooling question for RF-45 clone - by Mayhem - 05-25-2012, 01:11 AM
RE: Tooling question for RF-45 clone - by DanH - 05-25-2012, 10:15 AM
RE: Tooling question for RF-45 clone - by ETC57 - 05-25-2012, 11:06 AM



Users browsing this thread: 1 Guest(s)