MetalworkingFun Forum › Machining › 3D Printing v
Inserts

Thread Modes
Inserts
Highpower Offline
JAFO
******
Posts: 4,369
Threads: 178
Joined: Feb 2012
Location: Missouri, USA
#10
01-31-2022, 05:00 PM
(01-31-2022, 12:42 PM)EdK Wrote: Willie,

I got the style with the reduced diameter at one end for the reason you suggested. Makes it easier to install straight. I'll post a picture of one of them so you can see that they also have ridges that go diagonally making them even less likely to pull out. I'll find the link to the eBay seller that I bought them from.

Ed

Ooooo.... I see that now. I like it! 6799

Thanks.
Willie
Reply
Thanks given by:


Messages In This Thread
Inserts - by EdK - 07-06-2021, 04:31 PM
RE: Inserts - by Highpower - 07-06-2021, 07:40 PM
RE: Inserts - by EdK - 07-06-2021, 08:46 PM
RE: Inserts - by EdK - 07-07-2021, 04:37 PM
RE: Inserts - by Highpower - 01-31-2022, 11:37 AM
RE: Inserts - by EdK - 01-31-2022, 12:42 PM
RE: Inserts - by Highpower - 01-31-2022, 05:00 PM
RE: Inserts - by Dr Stan - 02-01-2022, 10:27 AM
RE: Inserts - by EdK - 07-09-2021, 04:05 PM
RE: Inserts - by Highpower - 07-09-2021, 08:58 PM
RE: Inserts - by EdK - 01-31-2022, 12:59 PM
RE: Inserts - by Highpower - 02-01-2022, 09:27 AM
RE: Inserts - by EdK - 02-01-2022, 11:12 AM
RE: Inserts - by Highpower - 02-01-2022, 01:45 PM
RE: Inserts - by rleete - 02-01-2022, 10:13 AM
RE: Inserts - by rleete - 02-01-2022, 02:17 PM
RE: Inserts - by Highpower - 02-01-2022, 02:48 PM
RE: Inserts - by EdK - 07-23-2022, 01:02 PM
RE: Inserts - by Highpower - 07-23-2022, 03:19 PM
RE: Inserts - by rleete - 07-24-2022, 04:51 PM
RE: Inserts - by Highpower - 07-24-2022, 08:00 PM
RE: Inserts - by EdK - 07-24-2022, 07:58 PM
RE: Inserts - by rleete - 07-25-2022, 07:33 AM
RE: Inserts - by Highpower - 07-25-2022, 11:10 AM



Users browsing this thread: 1 Guest(s)