Another question Ed. What formula are you using to determine what size hole to make, in relation to the OD of the inserts?
Willie
|
Inserts
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
RE: Inserts - by Highpower - 07-06-2021, 07:40 PM
RE: Inserts - by EdK - 07-06-2021, 08:46 PM
RE: Inserts - by EdK - 07-07-2021, 04:37 PM
RE: Inserts - by Highpower - 01-31-2022, 11:37 AM
RE: Inserts - by EdK - 01-31-2022, 12:42 PM
RE: Inserts - by Highpower - 01-31-2022, 05:00 PM
RE: Inserts - by Dr Stan - 02-01-2022, 10:27 AM
RE: Inserts - by EdK - 07-09-2021, 04:05 PM
RE: Inserts - by Highpower - 07-09-2021, 08:58 PM
RE: Inserts - by EdK - 01-31-2022, 12:59 PM
RE: Inserts - by Highpower - 02-01-2022, 09:27 AM
RE: Inserts - by EdK - 02-01-2022, 11:12 AM
RE: Inserts - by Highpower - 02-01-2022, 01:45 PM
RE: Inserts - by rleete - 02-01-2022, 10:13 AM
RE: Inserts - by rleete - 02-01-2022, 02:17 PM
RE: Inserts - by Highpower - 02-01-2022, 02:48 PM
RE: Inserts - by EdK - 07-23-2022, 01:02 PM
RE: Inserts - by Highpower - 07-23-2022, 03:19 PM
RE: Inserts - by rleete - 07-24-2022, 04:51 PM
RE: Inserts - by Highpower - 07-24-2022, 08:00 PM
RE: Inserts - by EdK - 07-24-2022, 07:58 PM
RE: Inserts - by rleete - 07-25-2022, 07:33 AM
RE: Inserts - by Highpower - 07-25-2022, 11:10 AM
|
Users browsing this thread: 2 Guest(s)