Precision Matthews PM-25MV Mill

Thread Modes

Precision Matthews PM-25MV Mill

EdK

Whipping Boy

Posts: 8,744
Threads: 314
Joined: Feb 2012
Location: Arizona/Minnesota

The following 1 user Likes EdK's post:
arvidj (04-03-2022)

#21

04-03-2022, 10:14 AM

I ran a Mitutoyo DTI over the length of the table and am happy with the results. Starting from the right end of the table and moving towards the left it quickly goes from zero to .0005 and stays at that for most of the way until it gets close to the left end. Then it gradually goes to .0015. I can live with that. I'm going to tram the head today and fire it up and see what happens.

Ed

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Precision Matthews PM-25MV Mill - by EdK - 03-27-2022, 04:38 PM

RE: Precision Matthews PM-25MV Mill - by f350ca - 03-27-2022, 07:17 PM

RE: Precision Matthews PM-25MV Mill - by Highpower - 03-27-2022, 07:25 PM

RE: Precision Matthews PM-25MV Mill - by EdK - 03-27-2022, 08:18 PM

RE: Precision Matthews PM-25MV Mill - by Highpower - 03-28-2022, 09:12 AM

RE: Precision Matthews PM-25MV Mill - by f350ca - 03-27-2022, 08:47 PM

RE: Precision Matthews PM-25MV Mill - by EdK - 03-27-2022, 09:39 PM

RE: Precision Matthews PM-25MV Mill - by Mayhem - 03-27-2022, 11:07 PM

RE: Precision Matthews PM-25MV Mill - by rleete - 03-28-2022, 07:58 AM