|
Dividing head from a right angle gearbox
|
05-27-2012, 02:05 PM
(This post was last modified: 05-27-2012, 02:05 PM by ScrapMetal.)
Nice Bob. As far as the plates go, are there any things that need to be considered (like the gearbox ratio)?
Also, while I'm asking things  , where did you source your gearboxes from? Thanks much, -Ron
11" South Bend lathe - Wells-Index 860C mill - 16" Queen City Shaper
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Dividing head from a right angle gearbox - by aametalmaster - 05-27-2012, 06:29 AM
RE: Dividing head from a right angle gearbox - by aametalmaster - 05-27-2012, 06:36 AM
RE: Dividing head from a right angle gearbox - by ScrapMetal - 05-27-2012, 02:05 PM
RE: Dividing head from a right angle gearbox - by aametalmaster - 05-27-2012, 02:14 PM
RE: Dividing head from a right angle gearbox - by ScrapMetal - 05-28-2012, 03:08 PM
RE: Dividing head from a right angle gearbox - by krv3000 - 05-28-2012, 01:35 AM
RE: Dividing head from a right angle gearbox - by DaveH - 05-28-2012, 02:01 PM
RE: Dividing head from a right angle gearbox - by Rickabilly - 06-12-2012, 06:40 AM
|
