Dividing head from a right angle gearbox

[aametalmaster]

(05-27-2012, 02:05 PM)ScrapMetal Wrote: Nice Bob. As far as the plates go, are there any things that need to be considered (like the gearbox ratio)?

Also, while I'm asking things , where did you source your gearboxes from?

Thanks much,

-Ron

The chart that came with the plates has a 40:1 and a 60:1 division table. The 40: had more options so i went with that.
The gearbox is a Radicon that is used on a satatellite dish setup and i got it cheap prob because if the hollow shafts and it was from ebay also. I think it was UK made...Bob