ER40 - How Thin?

Thread Modes

ER40 - How Thin?

Vinny

Another Whipping Boy

Posts: 2,597
Threads: 99
Joined: Dec 2014
Location: Michigan

02-06-2023, 01:31 PM

What is the thinnist piece of metal an ER40 will hold so you can face it? It will be 25mm diameter, will it hold a 2mm thick disk with some sticking out to face it? The material will actually be brass. I don't have the collet or chuck yet so I can't check myself.

Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique

Website

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

ER40 - How Thin? - by Vinny - 02-06-2023, 01:31 PM

RE: ER40 - How Thin? - by EdK - 02-06-2023, 10:24 PM

RE: ER40 - How Thin? - by Vinny - 02-06-2023, 11:46 PM

RE: ER40 - How Thin? - by Dr Stan - 02-07-2023, 11:18 AM

RE: ER40 - How Thin? - by Highpower - 02-07-2023, 11:45 AM

RE: ER40 - How Thin? - by Vinny - 02-07-2023, 11:59 AM

RE: ER40 - How Thin? - by EdK - 02-07-2023, 02:38 PM

RE: ER40 - How Thin? - by Highpower - 02-07-2023, 08:33 PM