Lathe chuck advice
#2
A four inch should be about the biggest you should swing due to the mass issue you cited. You may want to take a look at Shars Tools. I've had good sucess with their products.
Reply
Thanks given by:


Messages In This Thread
Lathe chuck advice - by rleete - 03-10-2023, 09:10 AM
RE: Lathe chuck advice - by Dr Stan - 03-11-2023, 11:29 PM
RE: Lathe chuck advice - by EdK - 03-12-2023, 11:57 AM
RE: Lathe chuck advice - by rleete - 03-12-2023, 01:16 PM
RE: Lathe chuck advice - by Vinny - 03-12-2023, 07:04 PM
RE: Lathe chuck advice - by EdK - 03-13-2023, 11:28 AM
RE: Lathe chuck advice - by rleete - 04-01-2023, 02:45 PM



Users browsing this thread: 3 Guest(s)