What should be the allowance for press fitting?
#31
(05-31-2012, 06:20 PM)stevec Wrote:
(05-31-2012, 12:43 PM)ukazak Wrote: ask me how many times stopped and check it. Sweat It is amezing I use the dials on the machine and it works.. but check it again anyways, when I start trusting thye dials, than will be real fun.RotflRotflRotfl
unal
Sorry unal, I don't understand17428
Steve

Steve, Smile
you were saying about "digital cliper reading and prescision" work. and I meant to say; I stop turning, to check it with the cliper reading, how much I went and start turning again with short intruptions to achieve the prescision, even though I feed with dial readings on the machine.
Reply
Thanks given by:


Messages In This Thread
What should be the allowance for press fitting? - by ukazak - 05-29-2012, 12:56 AM
RE: What should be the allowance for press fitting? - by ukazak - 05-29-2012, 12:37 PM
RE: What should be the allowance for press fitting? - by ukazak - 05-29-2012, 03:09 PM
RE: What should be the allowance for press fitting? - by ukazak - 05-29-2012, 04:03 PM
RE: What should be the allowance for press fitting? - by ukazak - 05-29-2012, 04:48 PM
RE: What should be the allowance for press fitting? - by ukazak - 05-29-2012, 05:05 PM
RE: What should be the allowance for press fitting? - by ukazak - 05-30-2012, 11:19 AM
RE: What should be the allowance for press fitting? - by ukazak - 05-31-2012, 12:46 PM
RE: What should be the allowance for press fitting? - by ukazak - 05-30-2012, 04:50 PM
RE: What should be the allowance for press fitting? - by ukazak - 05-31-2012, 12:43 PM
RE: What should be the allowance for press fitting? - by ukazak - 06-01-2012, 03:11 AM
RE: What should be the allowance for press fitting? - by ukazak - 06-01-2012, 02:17 PM
RE: What should be the allowance for press fitting? - by ukazak - 06-01-2012, 03:57 PM



Users browsing this thread: 2 Guest(s)