MetalworkingFun Forum › Machinery › Lathes v
Lathe Chuck Backing Plate

Thread Modes
Lathe Chuck Backing Plate
Dell Offline
Freshman
**
Posts: 15
Threads: 5
Joined: Dec 2023
Location: Uk
The following 2 users Like Dell's post:
EdK (12-09-2023), Highpower (12-09-2023)
#7
12-09-2023, 08:25 AM
I made a new backplate recently for my four jaw chuck out of cast iron because some idiot had made it out of aluminium ,I had never turned cast before but found it very nice to turn albeit very messy .
Dell
Old man but still learning 
Reply
Thanks given by:


Messages In This Thread
Lathe Chuck Backing Plate - by Cross Slide - 11-19-2023, 09:56 PM
RE: Lathe Chuck Backing Plate - by Cross Slide - 11-19-2023, 10:05 PM
RE: Lathe Chuck Backing Plate - by EdK - 11-19-2023, 10:47 PM
RE: Lathe Chuck Backing Plate - by Highpower - 11-20-2023, 05:54 AM
RE: Lathe Chuck Backing Plate - by Cross Slide - 11-20-2023, 08:21 AM
RE: Lathe Chuck Backing Plate - by EdK - 11-20-2023, 10:55 AM
RE: Lathe Chuck Backing Plate - by Dell - 12-09-2023, 08:25 AM



Users browsing this thread: 1 Guest(s)