Help MYFORD RACK PINION ASSEMBLY.
#2
(02-17-2024, 04:12 PM)bodger Wrote: Hello, I have a tooth missing on the gear that interacts with the long toothed rack on my Myford ML7. I does not seem to affect the operation of the lathe. I have stripped the lathe apart for a deep clean and that is when I found it. Apart from replacing due to cost I would welcome ideas on how to fix this. There are two gears which I believe are pressed together and if I could get them apart I could perhaps drill where the missing tooth is tap the holes and fit studs then file to shape. Thank you all in advance. I tried to post a message earlier but I think that it failed.

Welcome to the forum bodger!

Can you post a picture of the damaged gear?

Ed
Reply
Thanks given by:


Messages In This Thread
MYFORD RACK PINION ASSEMBLY. - by bodger - 02-17-2024, 04:12 PM
RE: MYFORD RACK PINION ASSEMBLY. - by EdK - 02-18-2024, 10:21 AM
RE: MYFORD RACK PINION ASSEMBLY. - by bodger - 02-19-2024, 08:51 AM
RE: MYFORD RACK PINION ASSEMBLY. - by bodger - 02-24-2024, 03:35 AM
RE: MYFORD RACK PINION ASSEMBLY. - by rleete - 02-24-2024, 09:28 AM
RE: MYFORD RACK PINION ASSEMBLY. - by EdK - 02-24-2024, 11:25 AM
RE: MYFORD RACK PINION ASSEMBLY. - by Vinny - 02-24-2024, 05:43 PM
RE: MYFORD RACK PINION ASSEMBLY. - by bodger - 02-25-2024, 06:37 AM
RE: MYFORD RACK PINION ASSEMBLY. - by bodger - 02-25-2024, 08:15 AM
RE: MYFORD RACK PINION ASSEMBLY. - by EdK - 02-25-2024, 12:36 PM



Users browsing this thread: 1 Guest(s)