06-08-2012, 01:51 PM
Hi Lads 
Made a start on the Z axis bearing mount ,,,,,, chopped a wee bit of one of my large lumps of scrapbinium .
![[Image: normal_P1040971.jpg]](http://www.nam-engineering.com/cm/albums/userpics/10002/normal_P1040971.jpg)
Slapped it in the CUB lathe ,, for turning and boring ,,,,,,,,,,,,ruffing shot.
![[Image: normal_P1040978.jpg]](http://www.nam-engineering.com/cm/albums/userpics/10002/normal_P1040978.jpg)
And a few hours later ,,,,,,,,,, all the turning and boring done .
![[Image: normal_P1040984.jpg]](http://www.nam-engineering.com/cm/albums/userpics/10002/normal_P1040984.jpg)
![[Image: normal_P1040985.jpg]](http://www.nam-engineering.com/cm/albums/userpics/10002/normal_P1040985.jpg)
Enough for today ,,,,,,,,,,,,,i will stick it on the mill tomorrow .
Rob
Made a start on the Z axis bearing mount ,,,,,, chopped a wee bit of one of my large lumps of scrapbinium .
Slapped it in the CUB lathe ,, for turning and boring ,,,,,,,,,,,,ruffing shot.
And a few hours later ,,,,,,,,,, all the turning and boring done .
Enough for today ,,,,,,,,,,,,,i will stick it on the mill tomorrow .
Rob