Motor control box
#19
That's it - bunch it up and shove it into the enclosure and close the door. Nobody will see it then!

I remember seeing some signal wiring that came out of one of the RAAF bases here, where they still laced the looms with cotton. It was tied at one end of the loom the it ran parallel for an inch or so and was tied around the circumference of the loom and then off parallel again until the next tie off. The tie offs were almost perfect crosses. The lacing was basically |-----|-----|-----|

Would have taken hours to do the whole system and there wasn't a loose bit of cotton to be seen (other than the start and finish tie points).
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Motor control box - by Mayhem - 06-09-2012, 10:58 PM
RE: Motor control box - by doubleboost - 06-10-2012, 06:50 AM
RE: Motor control box - by Highpower - 06-10-2012, 07:40 AM
RE: Motor control box - by DaveH - 06-10-2012, 08:59 AM
RE: Motor control box - by stevec - 06-10-2012, 06:53 AM
RE: Motor control box - by krv3000 - 06-10-2012, 04:32 PM
RE: Motor control box - by EdK - 06-10-2012, 05:42 PM
RE: Motor control box - by Mayhem - 06-10-2012, 08:17 PM
RE: Motor control box - by Rickabilly - 06-11-2012, 08:04 AM
RE: Motor control box - by stevec - 06-11-2012, 03:43 PM
RE: Motor control box - by Hopefuldave - 06-13-2012, 04:43 PM
RE: Motor control box - by Rickabilly - 06-14-2012, 06:41 AM
RE: Motor control box - by stevec - 06-14-2012, 06:52 AM
RE: Motor control box - by Rickabilly - 06-14-2012, 08:59 AM
RE: Motor control box - by Mayhem - 06-13-2012, 05:37 PM
RE: Motor control box - by Tony Wells - 06-14-2012, 07:17 AM
RE: Motor control box - by Mayhem - 06-14-2012, 09:51 AM
RE: Motor control box - by Rickabilly - 06-14-2012, 10:02 AM
RE: Motor control box - by Mayhem - 06-14-2012, 10:11 AM
RE: Motor control box - by Hopefuldave - 06-14-2012, 01:23 PM
RE: Motor control box - by Rickabilly - 06-14-2012, 01:42 PM



Users browsing this thread: 1 Guest(s)