MetalworkingFun Forum › Machinery › Milling Machines v
Degree Finder or DRO Question

Thread Modes
Degree Finder or DRO Question
ETC57 Offline
Junior
****
Posts: 576
Threads: 18
Joined: Feb 2012
Location: Washington State USA
#4
06-17-2012, 08:50 PM
Ya like mine good idea X-ray,Thumbsup


When I raze or lower the head on my mill it always drifts a little left or right, so I make every effort not to move it.Blush

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:


Messages In This Thread
Degree Finder or DRO Question - by November X-ray - 06-17-2012, 05:40 PM
RE: Degree Finder or DRO Question - by ScrapMetal - 06-17-2012, 08:08 PM
RE: Degree Finder or DRO Question - by DaveH - 06-17-2012, 08:20 PM
RE: Degree Finder or DRO Question - by ETC57 - 06-17-2012, 08:50 PM
RE: Degree Finder or DRO Question - by f350ca - 06-17-2012, 11:22 PM
RE: Degree Finder or DRO Question - by November X-ray - 06-18-2012, 05:25 AM
RE: Degree Finder or DRO Question - by stevec - 06-18-2012, 07:38 AM
RE: Degree Finder or DRO Question - by November X-ray - 06-18-2012, 08:00 AM
RE: Degree Finder or DRO Question - by EdK - 06-18-2012, 10:33 AM
RE: Degree Finder or DRO Question - by Highpower - 06-18-2012, 02:02 PM
RE: Degree Finder or DRO Question - by ScrapMetal - 06-18-2012, 02:17 PM
RE: Degree Finder or DRO Question - by Highpower - 06-18-2012, 03:14 PM
RE: Degree Finder or DRO Question - by November X-ray - 06-18-2012, 04:49 PM
RE: Degree Finder or DRO Question - by stevec - 06-19-2012, 06:45 AM
RE: Degree Finder or DRO Question - by ScrapMetal - 06-19-2012, 01:51 PM



Users browsing this thread: 1 Guest(s)