How to Indicate A Vise in Just One pass
#48
(06-19-2012, 12:30 PM)TomG Wrote: Here's a little video I made showing how to indicate a milling vise in just one pass.

Tom




Thank you Tom, for such a simple relatively elegant solution for the tramming.
best regards, from
john aka castellated nut.
Reply
Thanks given by:


Messages In This Thread
How to Indicate A Vise in Just One pass - by TomG - 06-19-2012, 12:30 PM
RE: How to Indicate A Vise in Just One pass - by Wawoodman - 09-08-2012, 11:26 AM
RE: How to Indicate A Vise in Just One pass - by Wawoodman - 09-08-2012, 09:12 PM
RE: How to Indicate A Vise in Just One pass - by castellated nut - 01-24-2019, 02:17 AM



Users browsing this thread: 1 Guest(s)