Machining an AR15 lower receiver
#53
(11-30-2013, 09:49 PM)d65 Wrote: Very impressive ! I wish I had your machining skills! I just finished an 80% AR Lower in cast aluminum and I thought I did a good job. In my defense, this was my first project on my new cheapo Grizzly mini mill. Never have used a mill or lathe before. You however, look like you may have been at this awhile!!! I love the learning curve.

I would love to see some pictures of your finished receiver.

Mine was a first effort on my cheapo Enco mill, so you aren't alone. Happyno
Willie
Reply
Thanks given by:


Messages In This Thread
Machining an AR15 lower receiver - by Highpower - 06-20-2012, 04:35 PM
RE: Machining an AR15 lower receiver - by EdK - 06-20-2012, 04:47 PM
RE: Machining an AR15 lower receiver - by EdK - 06-20-2012, 05:03 PM
RE: Machining an AR15 lower receiver - by EdK - 06-20-2012, 04:55 PM
RE: Machining an AR15 lower receiver - by stevec - 12-01-2013, 07:28 AM
RE: Machining an AR15 lower receiver - by TomG - 06-20-2012, 05:10 PM
RE: Machining an AR15 lower receiver - by TomG - 06-20-2012, 05:41 PM
RE: Machining an AR15 lower receiver - by ETC57 - 06-20-2012, 06:12 PM
RE: Machining an AR15 lower receiver - by RobWilson - 06-21-2012, 09:12 AM
RE: Machining an AR15 lower receiver - by TomG - 06-21-2012, 01:49 PM
RE: Machining an AR15 lower receiver - by TomG - 06-21-2012, 04:33 PM
RE: Machining an AR15 lower receiver - by DaveH - 06-21-2012, 03:26 PM
RE: Machining an AR15 lower receiver - by RobWilson - 06-22-2012, 10:51 AM
RE: Machining an AR15 lower receiver - by TomG - 06-21-2012, 10:17 PM
RE: Machining an AR15 lower receiver - by Mayhem - 06-21-2012, 10:30 PM
RE: Machining an AR15 lower receiver - by TomG - 06-22-2012, 06:28 AM
RE: Machining an AR15 lower receiver - by DaveH - 06-22-2012, 09:25 AM
RE: Machining an AR15 lower receiver - by DaveH - 06-29-2012, 08:38 PM
RE: Machining an AR15 lower receiver - by TomG - 06-29-2012, 08:46 PM
RE: Machining an AR15 lower receiver - by d65 - 11-30-2013, 09:49 PM
RE: Machining an AR15 lower receiver - by Highpower - 12-22-2013, 07:26 AM



Users browsing this thread: 1 Guest(s)