Machining an AR15 lower receiver
#23
(06-21-2012, 01:49 PM)TomG Wrote: Supposedly, lower forgings can be purchased directly from Brass Aluminum Forging Enterprises of Ferndale, MI. for $13 each. I haven't verified this, but the link with all of the contact information is on the forum at CNCGuns.

Tom

Thanks Tom. I'll look into that as well. I've got to warn you though, when my wife asks, "Why?" I am going to point the blame at you. Tongue

-Ron Angel
11" South Bend lathe - Wells-Index 860C mill - 16" Queen City Shaper
Reply
Thanks given by:


Messages In This Thread
Machining an AR15 lower receiver - by Highpower - 06-20-2012, 04:35 PM
RE: Machining an AR15 lower receiver - by EdK - 06-20-2012, 04:47 PM
RE: Machining an AR15 lower receiver - by EdK - 06-20-2012, 05:03 PM
RE: Machining an AR15 lower receiver - by EdK - 06-20-2012, 04:55 PM
RE: Machining an AR15 lower receiver - by stevec - 12-01-2013, 07:28 AM
RE: Machining an AR15 lower receiver - by TomG - 06-20-2012, 05:10 PM
RE: Machining an AR15 lower receiver - by TomG - 06-20-2012, 05:41 PM
RE: Machining an AR15 lower receiver - by ETC57 - 06-20-2012, 06:12 PM
RE: Machining an AR15 lower receiver - by RobWilson - 06-21-2012, 09:12 AM
RE: Machining an AR15 lower receiver - by TomG - 06-21-2012, 01:49 PM
RE: Machining an AR15 lower receiver - by ScrapMetal - 06-21-2012, 04:19 PM
RE: Machining an AR15 lower receiver - by TomG - 06-21-2012, 04:33 PM
RE: Machining an AR15 lower receiver - by DaveH - 06-21-2012, 03:26 PM
RE: Machining an AR15 lower receiver - by RobWilson - 06-22-2012, 10:51 AM
RE: Machining an AR15 lower receiver - by TomG - 06-21-2012, 10:17 PM
RE: Machining an AR15 lower receiver - by Mayhem - 06-21-2012, 10:30 PM
RE: Machining an AR15 lower receiver - by TomG - 06-22-2012, 06:28 AM
RE: Machining an AR15 lower receiver - by DaveH - 06-22-2012, 09:25 AM
RE: Machining an AR15 lower receiver - by DaveH - 06-29-2012, 08:38 PM
RE: Machining an AR15 lower receiver - by TomG - 06-29-2012, 08:46 PM
RE: Machining an AR15 lower receiver - by d65 - 11-30-2013, 09:49 PM



Users browsing this thread: 1 Guest(s)