Machining an AR15 lower receiver

[Highpower]

(06-29-2012, 08:38 PM)DaveH Wrote: Ah well, one does have to admire his spirit.

Indeed Dave! A+ for effort!

I bet Bob (krv3000) with just a file and a hacksaw could do it

DaveH

I do believe you are right about that too Dave. But Bob has the experience behind him to make it work and it shows. This poor guy on the other hand knew nothing about machine work and wanted to give it a try because he saw others doing it. Had he gotten some better advice in the beginning it could have been much more enjoyable for him instead of frustrating.

Willie