MetalworkingFun Forum › Machinery › Lathes v
My Next Project - Meister 2 Axis DRO for my Lathe

Thread Modes
My Next Project - Meister 2 Axis DRO for my Lathe
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#4
06-26-2012, 07:09 AM (This post was last modified: 06-26-2012, 07:10 AM by Mayhem.)
I was thinking that too Willie, until I read:

(06-25-2012, 10:56 PM)henryarnold Wrote: ...You might notice that the compound scale is extra small...

Perhaps saddle and compound only - no cross slide?
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
RE: My Next Project - Meister 2 Axis DRO for my Lathe - by Mayhem - 06-26-2012, 07:09 AM



Users browsing this thread: 1 Guest(s)