10-27-2012, 09:19 AM
OK - I managed to get this apart. I didn't think about using a slide hammer until it was suggested on another forum 
So I made an attachment that slid under the nut and removed the shaft the gear slides on (along with the gear, fork and bearing):
The assembly
Pond scum!
The new tool (note the slide hammer attaches so it is centred over the shaft)
So I made an attachment that slid under the nut and removed the shaft the gear slides on (along with the gear, fork and bearing): The assembly
Pond scum!
The new tool (note the slide hammer attaches so it is centred over the shaft)
Hunting American dentists since 2015.