|
Standard for spindle nose thread
|
07-08-2012, 04:46 PM
(07-08-2012, 09:48 AM)Mayhem Wrote: Hi Tom - Sorry but I'm not sure I follow. I'm having a hard time visualising what you have described. Is it a 4" long rod with a 60º point on both ends? Yup, roughly 4" long. You'll need to fit it to an existing thread to get the exact length, then you can use it as a gauge to cut a new thread with the same pitch diameter. Tom ![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Standard for spindle nose thread - by Mayhem - 07-08-2012, 02:34 AM
RE: Standard for spindle nose thread - by Highpower - 07-08-2012, 07:43 AM
RE: Standard for spindle nose thread - by DaveH - 07-08-2012, 07:47 AM
RE: Standard for spindle nose thread - by Mayhem - 07-08-2012, 08:57 AM
RE: Standard for spindle nose thread - by TomG - 07-08-2012, 09:31 AM
RE: Standard for spindle nose thread - by Mayhem - 07-08-2012, 09:48 AM
RE: Standard for spindle nose thread - by TomG - 07-08-2012, 04:46 PM
RE: Standard for spindle nose thread - by dallen - 07-08-2012, 05:07 PM
RE: Standard for spindle nose thread - by TomG - 07-08-2012, 06:58 PM
RE: Standard for spindle nose thread - by Mayhem - 07-09-2012, 04:58 AM
RE: Standard for spindle nose thread - by Tony Wells - 07-09-2012, 07:04 AM
RE: Standard for spindle nose thread - by Mayhem - 07-09-2012, 08:05 AM
|
