MetalworkingFun Forum › Machinery › Lathes v
For the miniature minded....

Thread Modes
For the miniature minded....
DaveH Offline
Child of the 60's
******
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
#6
07-27-2012, 01:28 PM
Hi Tom,
I noticed the tail stock, and now you have mentioned it the apron hand wheel, and the chuck key.
I wonder if he had a specific reason for doing it.
Smiley-eatdrink004
DaveH
Reply
Thanks given by:


Messages In This Thread
For the miniature minded.... - by Highpower - 07-27-2012, 10:55 AM
RE: For the miniature minded.... - by EdK - 07-27-2012, 11:28 AM
RE: For the miniature minded.... - by doubleboost - 07-27-2012, 12:10 PM
RE: For the miniature minded.... - by DaveH - 07-27-2012, 12:52 PM
RE: For the miniature minded.... - by TomG - 07-27-2012, 01:15 PM
RE: For the miniature minded.... - by Highpower - 07-27-2012, 06:18 PM
RE: For the miniature minded.... - by DaveH - 07-27-2012, 01:28 PM
RE: For the miniature minded.... - by TomG - 07-27-2012, 01:51 PM
RE: For the miniature minded.... - by EdK - 07-27-2012, 03:54 PM
RE: For the miniature minded.... - by Highpower - 07-27-2012, 06:36 PM
RE: For the miniature minded.... - by dallen - 07-28-2012, 10:04 AM
RE: For the miniature minded.... - by sasquatch - 07-27-2012, 07:18 PM
RE: For the miniature minded.... - by stevec - 07-27-2012, 07:24 PM
RE: For the miniature minded.... - by EdK - 07-27-2012, 09:42 PM
RE: For the miniature minded.... - by Highpower - 07-27-2012, 11:44 PM
RE: For the miniature minded.... - by f350ca - 07-27-2012, 10:30 PM
RE: For the miniature minded.... - by nel2lar - 08-05-2012, 07:28 PM
RE: For the miniature minded.... - by Highpower - 08-21-2012, 08:57 AM



Users browsing this thread: