MetalworkingFun Forum › Machinery › Lathes v
For the miniature minded....

Thread Modes
For the miniature minded....
EdK Offline
Whipping Boy
*******
Posts: 8,749
Threads: 314
Joined: Feb 2012
Location: Arizona/Minnesota
#8
07-27-2012, 03:54 PM
(07-27-2012, 01:51 PM)TomG Wrote: Probably lack of room for additional gearing in the apron, but the chuck and tailstock could have been made using left hand threads. Although he would probably have had to make the LH taps.

While we are on the subject of miniature modeling, has anyone see the work of this guy?

My. Y. Park

Tom

Wowser!! Unbelievable! Worthy

Ed
Reply
Thanks given by:


Messages In This Thread
For the miniature minded.... - by Highpower - 07-27-2012, 10:55 AM
RE: For the miniature minded.... - by EdK - 07-27-2012, 11:28 AM
RE: For the miniature minded.... - by doubleboost - 07-27-2012, 12:10 PM
RE: For the miniature minded.... - by DaveH - 07-27-2012, 12:52 PM
RE: For the miniature minded.... - by TomG - 07-27-2012, 01:15 PM
RE: For the miniature minded.... - by Highpower - 07-27-2012, 06:18 PM
RE: For the miniature minded.... - by DaveH - 07-27-2012, 01:28 PM
RE: For the miniature minded.... - by TomG - 07-27-2012, 01:51 PM
RE: For the miniature minded.... - by EdK - 07-27-2012, 03:54 PM
RE: For the miniature minded.... - by Highpower - 07-27-2012, 06:36 PM
RE: For the miniature minded.... - by dallen - 07-28-2012, 10:04 AM
RE: For the miniature minded.... - by sasquatch - 07-27-2012, 07:18 PM
RE: For the miniature minded.... - by stevec - 07-27-2012, 07:24 PM
RE: For the miniature minded.... - by EdK - 07-27-2012, 09:42 PM
RE: For the miniature minded.... - by Highpower - 07-27-2012, 11:44 PM
RE: For the miniature minded.... - by f350ca - 07-27-2012, 10:30 PM
RE: For the miniature minded.... - by nel2lar - 08-05-2012, 07:28 PM
RE: For the miniature minded.... - by Highpower - 08-21-2012, 08:57 AM



Users browsing this thread: 1 Guest(s)